Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are having ASA 5580 in active-standby mode all interfaces are gig interfaces, due to high traffic on inside interface we want to bundle two ports for inside. Now problem is that the device is under production and is having more than around 400 lin...
Hi,
I have a 6509-E chassis deployed as WAN termination router, only having the following links connected to it :-
3 port etherchannel connecting to ISP for 3gig uplink (ports Gi1/1-3)Downlink-1 1gig (Gi2/1)Downlink-2 1gig (Gi2/3)Downlink-3 1gig (Gi...
Hi
We have 2 WAN links of 1Gbps each, can I terminate them on a C6509 with sup720 card in it.
I doubt it because I don't think 6509 will provide me with required throughput in my case.
Regards,
Bhushit
Hi,
I want to block unicast/multicast flooding on cisco 6509 (only L2 capabilities).
The packets destined for a mac not known to the switch are unicast/multicast flooded to all ports of the switch, but I have a couple of ports connected to critical ...
Hi
How can I assign another ip address to an interface on ASA5580, actually my ip range (172.16.31.0/24) already got exhausted, and I have neighboring range in use elsewhere so want to assign different range(172.16.41.0/24) for other hosts in that zo...
With restart, I was referring to that method of swapping the startup-config with new configuration.
" I suggest copying the running config out, change the interface configuration to have portchannel, then copy it back to the primary ASA's running-c...
Hi,
If I remove netflow from my WAN interface, switch utilization goes down to 10-15 %.
Without changing any other parameter. Most resource heavy service now is "slcp process".
Regards,
Yes I have netflow enabled on link to ISP
I am only receiving a single route (default route) from isp through bgp so that isnt a problem, also I haven't fully utilized the cef route cache.
High utilization seems to be due to netflow traffic and nat i...
From what I came to understand, I got the following observations investigating my config and chassis :
Almost all of punted packets are of netflow Switch is sending ICMP TTL expired messages "171850 time exceeded"Don't know why this below packet is p...
