Hello,
I am having a problem with a stack of four 2960x switches.
Before stacking the switches, I assigned them each a priority (15, 14, 13, and 12) based on the order in which they are racked.
I stacked them together, the stack reloaded, and yet...
Hello,
I am trying to upgrade a stack of 2960-X switches with a single command.
I have the .bin file on a USB thumb drive. I plug the device into the stack master, and it is recognized by the switch. I can see the .bin file on the usbflash0: inter...
Hi Leo,
Actually, at least in the case of 2960x, each individual switch considers itself a stack of one, and so a priority can be set on an un-stacked individual switch by using
(config)# switch 1 priority ___
Supposedly, when the switches are sta...
Yes - thank you for pointing that out, Rick. Looking at his partial config I think I may have misunderstood what he was asking for in his original question.
Hi Eckzyzxx45,
For the User EXEC mode, you can connect via console or virtual terminal line.
A username/password requirement can be set for these, by issuing the "line" command from global configuration mode.
configure terminal
line console 0
log...
Yes that is another option I had tested, thank you for the suggestion. Downtime is not a factor in my situation as this is a new shipment and all the switches are sitting on pallets, unpowered.
Thank you for the tip about archving and low-level code...