Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I'm running a 4331 with isr4300-universalk9.16.09.05.SPA.bin code.
Get a feature error/warning when applying "service-policy output TRAFFIC-OUT-POLICY" on a Dialer interface. Is this a code feature limitation?
Priority feature is not support...
Hello,
I'm looking at migrations from Nexus 7 to ACI v4.21.
On the nexus there is a RP statement setup as:
ip pim rp-address 10.2.1.1 group-list 239.255.1.0/24
On the ACI I'm not clear on how to create the same? Any guides or advise on how to do th...
Hi All, We keep experiencing random bad call quality on one of our dial peer's and noticed this is in the logs: %SIP-5-DIALPEER_STATUS: VoIP dial-Peer <3002> is Busied out020026: Feb 2 03:06:05.008 GMT: %SIP-5-DIALPEER_STATUS: VoIP dial-Peer <3002> ...
Hi,
I have a NX-OS 3548 runing 6.0(2)A8(2). I've run into an issue with I cannot create a second MIB community. I could only create a single MIB community. When I try to create a second MIB community I get an error that says "cannot make changes...
Hi,
I'm looking for some direction around SPT best practise. I'm wondering if its considered to be best practise that a switch should act as a root bridge where the first routable SVI instance is located. IE. We have vlan 100 on switch A with the...
Thanks Jon. If a packet is traversing this node heading towards this destination which routing table will be used? I can't use traceroute so having to do this manually.
Thanks Cofee.
I don't understand what the intent was either?
I'm still puzzled though what the effect would be even if we incorporated that into another route-map as seq 30. If subnet 10.10.13.13/32 matched in seq 20 with a community then applie...
