Hi   I have a 2960 Switch and am trying to set it up for a practice lab. IWhen I set up my cabling I notice that one of the ports on the 2960 switch only light up amber not green like the others do. I have used the same cable in other ports on the sw...

I have a new cisco 2960 switch but when I connect to it using teraterm it just given me a blank screen. I can use the same laptop on other switches that were donated to us but not on any of the new ones. I tried basic setup but only the Main LED ligh...

My school has purchased a dozen new switches for me to to teach Introduction to Networking, and when I connect to the switch with the console cable and teraterm i get a blank screen. I have followed the steps using basic express setup from online doc...