Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have the problem when I install a new AP that is causing a broadcast in the VLAN frome the AP.This broadcast is so strong that there are disconnections and other devices also start a broadcast.Broadcast requests are requests for IP addresses ...
Hello,
my access points are all at TX Power on Global. I can see that many only stand on TX Power Level 5. However, this is not enough to expose the WLAN far enough. If I manually set the access points to Power Level 1 or 2, my wireless network is ...
Hello,
i have two WLC Controller in the same Network und same VLAN, the APs are also in the same VLAN.
Both WLC have AP Wireless Clients online and the same RF Group. But both are RF Leaders and not see the antoher WLC?
Thanks for the first help. I also have a Cisco Prime in use so I could see clearly that TX Power Level 5 is far too low.
I actually have more than 100 AccessPoints. That's why manual adjustment is not the answer.
Version is 8.2.164.0 both.
Yes, same name under Controller TAB in Default Mobility Domain Name and RF Group Name on both WLC. The Name from RF Group Name and Default Mobility Domain Name is identical, is this a fail?
Yes, both WLC in the same Mobility Group. The WLC see the another but both says from other WLC:
Status: Control and Data Path Down
I see both WLC say Mutlicast IP : 0.0.0.0 but a Multicast IP is configured on Controller -> General
