Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am replacing existing ASA 5520 8.4 firewall with ASA 5545X 9.5, I am migrating the configuration from the existing firewall to the new one. What I have done so far, I have extracted the 8.4 configuration and applied it on the 9.5 section by s...
Hello,We currently have to ASA 5500 on two different locations each connected to the Internet, One firewall is the primary gateway for internet bound traffic and configured with OSPF and a static route 0 0 to the Border Router and 1 metric. The LAN i...
Hello,I am trying to connect a 2960 swith to 3560X using port channel. I have configred the switches with the following configratuion and connected them with straight ethernet cable, the link came up and then it went int err-disable state. I re-enabl...
We have a Site that is connected via Wireless Bridge to the Main Site, the site is on separate VLAN with Cisco 3560 switch. The main site has 6509 swith. Configuration as per attached diagram. We are connecting a fiber between the remote and the main...
Thank you for the response on this, however apparently route-map is redistricted by license. I do not have the set ip next-hop option. Is there any other way to do this. Best regards
