Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Fix this issue: Move HA/Failover Link to other ports than port 1/7 + 1/8, if possible. - Break HA - Move the physical cable(s) used for HA link - Establish HA again Disable PoE on port 1/7 + 1/8 -> Deploy configTry to upgrade now. Iif it fails do ...
Experiences the same issue on FMC and FTD on version 7.2.4. After I issued the "pmtool restartById sftunnel" on both sides, the registration went through with success.
It is not just cosmetic. Sometimes the services will be in a "not running" state, and no matter what you do, they will not start running. If so, please issue the "application configure ise" and first select "9: Create Missing Config Indexes" and then...
Hi I had the same issue, but fixed it by disabling dnssec ("no ip dnssec" via CLI). After that was done, I tried again and it worked right away. BRAndreas Foerby
I just did a re-image of a 3595 to version 3.0 via KVM and virtual CD/DVD drive. It was stuck at step CARSisePKg1 and CARSisePKg2 for a very long time, but it went through all steps 596/596 after approx. 5 hours - the post installation steps took onl...
@kmorris78 I have used SCEPman in several AzureAD w. Intune deployments to issue certificates to the devices. It works like a charm.
Just remember to include the devicename as Subject Alternative Names in the certificates, and then use "SAN" as the i...
