Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , all :I meet some issue when i using GNS3 (v2.2.5) to simulate VXLAN & EVPN on Cisco NX-OSv 7.3.0 ,and i made some paper to describe my question clearly as attachment , If anyone has some know-how about this , Pls give me a hand !!Thx
ISE version : 2.4.0.357 i cannot input any value on Radius:NAS-Filter-Rule , refer the attachment (how can i add content in this field.jpg) , path : Authorization Profile--->Advanced Attributes Settings --->select Radius:NAS-Filter-Rule , and i want...
when i connect my laptop on switch in ISE environment , it will be auto discovery via ISE , and list in Home-->summary-->total endpoints :and put this MAC entry in table :When i test 802.1x MACauth via ISE , it always pass due to this MAC existed , a...
after i setup and check TACACS log , it display this error msg "22056 Subject not found in the applicable identity store(s)"anything i miss to configure ? or which part i should adjust setting ? ISE verison:2.4.0 detail steps like this : Steps 13013...
as title , if i connect NB(MAC=00:21:70:FB:76:AA) on ISE environment , ISE default will auto discovery its MAC and put that in whitelist : could i adjust this default setting ? i don't want client auto be discovery via ISE , i want to add client MAC...
thanks for your reply , after i checked logs , endpoint profile is "unknown" , and everytime PC/NB connect on this environment , the MAC will auto discovery and list on this profile : may i adjust it to another profile ? like "workstation" or "profi...
thanks for your reply , my laptop MAC will be auto discovery in unknown list :and MAC-auth will pass if this MAC existed on this table , and i cannot remove it manually . Authentication policy like this :authorization policy like this :in my opinion ...
thanks for your reply , after i checked the logs , there is nothing in "matched command set" but i do configured the rule and make sure it be hit , it is called "tacacs for low power" : why it cannot hit this command sets ? any setting i need to adju...
