Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I config my E0/0 Interface with"ip ospf network non-broadcast" command,I want this interface to use unicast to hello neighbor.As I issue "neighbor x.x.x.x" under ospf process, it told me that:OSPF: Neighbor command is allowed only on NBMA and point-t...
My client wants to install two different types of antenna (one for ANT-4941 and another for ANT-1728) on AP1200. I am not sure what will happen with the combination. Would anybody give me some suggestions?
I think I know what's the problem.I previously configured VL to the neighbor peer. I took it away then I had no issue to put neighbor command under ospf process.Sure, I could still command VL under ospf process.But I dont know the reason why I cannot...
i've tried every type of ospf network interface, and it didnt work.no matter which interface type i configured, or left it default, i still cannot issue neighbor under ospf process.
