HiHow can I add the folllowing access-list to work once every month for 24 hrs from 12am-12am on PIX-525-6.3 Version . I do not have ASDM installed on it so I need command line only.access-list 102 permit ip host 16.19.x.y host 10.32.1.25Thanks
HiHow can I see the transactions between two hosts that are trying to talk to each other over certain ports .I am trying to find out ports needed to be opened for successful connection .I have tried "sh log" but I do not see those two hosts..The foll...
Question: I see this message for CPU,MEMORY,TRAFFIC,INTERFACE Stats.Any ideas ?Eveything is working except I see this message.It has ASA 5540 VER 8.2 and ASDM 6.2Thanks
HiI have ASA with subinterfaces/vlans for DMZ.The DMZ network has a single switch with no layer-3 vlans in it .The devices that were connected to this switch were down other day due to switch hardware failure.Is there a way I can make sure that thes...
I think I will have to rephrase my problem....I am trying to see if there are any denials for particular source reaching a specific destination.The problem I have is that I opened up a port 8081 between two hosts A and B I am told that hostA is not ...
10.32.254.5 and 144.1.4.85 are vpn routers that are part of vlan interfaces on this 4006 switchoo172.27.200.0 is terminating on these two vpn routers for 2 different tunnels.10.32.0.0/16 is behind 10.32.254.5 and 144,1,0.0/16 is behind 144.1.4.85
say I have two ASAs...When switch of Primary ASA goes down..does primary fails over to secondary and all those devices through secondary now ?Also Daul honed means Network card Teaming you are refering to ?
I used this link and this link doesn't talk about problem..Any idea ?http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a00800ef7b2.shtmlHow do I go back to that old thread I started ?
