Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I've a quick question about bridged mode in an ACE module.Is it possible to have the servers on a separate subnet rather than on a directly connected VLAN? Due to limitations brought on by physical aspects of the setup (and also security poli...
Hi all,I've run into an issue and I'm hoping one (or more!) of you have seen this before.I've configured an ASA5505 to be Lan to Lan VPN tunnel endpoint, peering with a linux box. The ASA is full licensed so that side isn't an issue.PROBLEM:When th...
Hi all,When configuring the ANM to import 6500 chassis' and ACE modules, I used an account whose password needs to be changed every so often.I've looked for a way to change the password in the ANM for this account however I can't seem to find where t...
HI all,I have a 6506-E here that randonly drops packets and I'm trying to find out why.When debugging ip packets (debug ip packet 52), I found a whole lot of these:May 4 22:42:14: pak 5007BF54 consumed in input feature , packet consumed, MCI Check(5...
Hi all,I'm hoping some of you helpful people on this forum can guide me or suggest a solution to a problem I'm faced with.I am currently load balancing exchange 2010 traffic via an ACE module. Software version is A2(3.3). I have most parts of it wo...
Hi,When you say that you can ping 192.168.1.2 from your personal laptop, where is that laptop connected? In the 192.168.1.0/24 network or the 192.168.2.0/24?I assume you're not trying to route traffic between the 819 and the E1200 and you just want ...
Check to ensure the switch doesn't have any q-in-q tunneling going on. If the other end of the l2tunnel has it's duplex out you'll see the message on this end as CDP is tunneled through the switch.R2(HD)-----(FD) SW (FD)------R1(FD) ...
Hi Mohammed,You'll need to provide more information. Is it a router? is it a switch? is it an access-point? What model and IOS?Without the above it is difficult for forum members to help.You may be able to try something like:show int | i is up|inpu...
Hi Andrew,You can also look at NBAR by matching the ICA protocol directly. I've looked at a 2821 running 12.4(25f) to get this config.Something like: class-map citrix match protocol citrix!policy-map citrix-map class citrix bandwidth 128 cla...
