Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm struggling to figure out exactly what symantec software is required for HA in LMS 3.2.I've read the LMS 3.2 HA docco but the Symantec product names used do not seem to exactly match those used by Symantec.Ideally if anyone has Symantec part nu...
Hi guys,I'm playing with WAAS for the firsttime in a LAB environment with some test kit. I have a number of WAE-512 that seem to crash at the BIOS boot stage if I have the extra 4 port card installed. If I take the card out they run fine.I'm running ...
Hi Guys,I'm trying to set up a sticky configuration on an ACE modeule in a 6500.I've got the loadbalancing woking happily but need to ammend the config to add stickiness.As far as I know the first command is someting on the lines of...sticky http-coo...
Hi The users and servers should be configured with the local 3560 VLAN interface IP address as their default gateway.If the 3G Modem is routing it will need to know how to get back to VLAN A & B. Adding routes to the 3G device directing return traffi...
If it's plugged into a switch that you have access to you could look in the arp table for the ip address.show arp | inc 123.123.123.123or look in the mac address table for the interface.show mac address-table interface fa0/1HTHSteve
Hi"ip domain name" specifies the domain name of the cisco device itself. One of the things this is used for is security certificate generation for IPSEC, SSH or HTTPS access. The certificate will be generated using the entries you put in for hostname...
pim nbma mode is used for multipoint nbma interfaces.pim normally maintains a database of (source / group) entries detailing which interface to send multicast traffic out of. If your frame relay connection is point to point then specifying which inte...
