Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have templates for networks that use the MX64. Recently for a new site a MX64W was ordered by mistake. I am wondering if I would be able to associate the MX64W to a template made specifically for the MX64?Any experience with his situation?
Hey @Johan3 Basic things first. Remember the MX is not a switch and does not speak STP and does not support UDLD either. So what you are dealing with is one switch only which is your root bridge too.Both ends of a link need to support UDLD for this f...
this is a rather old thread. I hope you found a fix.The way to point a static route to the LAN devices:- Use a "transit" vlan between your MX and the LAN device (L3 switch)- Point the static to the L3 switch ip address on that "transit" vlan.
@Woosie have you actually used those VANTEV antennas and cables you are mentioning with a MX67C? Im curious to know if it really worked fine and solved your problem.
