Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have configured HSRP using SVI interface on Nexus switches but we are getting both active and standby state is "unknown". Also showing the below output error. Could you please provide any solution.Vlan249 - Group 249 (HSRP-V2) (IPv4)Local state...
Ran into an interesting problem, seems EEM (script) cli commands have a character limit. Was curious if its a hard limitation of if it can be increased.Here is the command in question:action 8.5 mail server "$_email_server" to "$_email_to" from "$_em...
Hi,We have EEM script and IP SLA config in place but when we are trying to test the failover (wan interface goes down on active router), the script didn’t auto-triggered, and failover doesn’t happen on the backup circuit, and it got aborted as we che...
24 is my vlanvPC Peer-link status---------------------------------------------------------------------id Port Status Active vlans-- ---- ------ -------------------------------------------------X PoX up 24
I have checked the interface status and its showing the below results, i tried to bounce the interface but still no luck.Vlan249 10.221.249.2 protocol-down/link-down/admin-up
Hi,We are getting the below output by using "debug event manager action cli" cmd.016540: Dec 14 13:10:11.073 GMT: %TRACK-6-STATE: 100 list threshold weight Up -> Down016541: Dec 14 13:10:11.076 GMT: %HA_EM-6-LOG: REDIRECT_ALL_TRAFFIC_TO_RTR02 : DEBUG...
Here is the Router 1 which is active and following is the EEM script:PUN-MTR-DIA-RTR01#sh run | sec eventevent manager environment _email_from [email protected] manager environment _email_to [email protected] manager environment _email_se...
