Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Am stuck with a problem getting a L2L VPN tunnel to our business partner.My side is running on ASA, the remote peer is a Palo Alto FW.Phase 1 is complete, but no IPSEC SAs are forming.NAT shows 0 hits. This is the output: show cryp isa sa de...
You can use any Cisco router. I use the IR829 as it is rated EX zone 1 for hazardous location. I would prefer to use other routers, as the IR829 has very limited port capacity.
Hi, Changes made as per suggestion, I've cleared cry isa sa and xlate, but still no response from the remote host.IKEv1 showing as MM Active.Packet tracer shows phase 12 VPN as DROP but the ACL shows hits. MYKULM12FW1/sec/act# show cry ikev1 saIKE Pe...
Thanks for the tips on how to run the uninstaller. After I ran the uninstaller, the session terminated and the SFR status remains unresponsive. Rebooted the ASA, and ASA shows the SFR as the same 6.2.3.8-51 version.[190109 23:30:58:548] BEGIN 200_p...
From my research L2TPV3 is for P2P only, but there are a few examples I have seen that mentioned P2MP, but using MPLS encapsulation.For my scenario, my network comprises of a flat network.spread over 11 platforms at sea, and the equipment (PLC) are l...
