Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have the below config which the peering works with the ISP. However, I need to subnet the IP to be distributed to all my customers like A.A.A.0/29 OR A.A.A.8/29. If I change the Gi0/1 IP address to A.A.A.1 255.255.255.248, the bgp fails. How ca...
Hi,
I need to disable SIP in my FTD.
However, I don't have the options to issue the below command
configure inspection sip disable
.
I only have the below:
audit_cert Change to Audit_cert Configuration Modeconfigure C...
Hi,
I just take ownership of a cisco 2911 with IOS ver 15.
I noticed that the command IP PMTU and IP DFBIT SET is no more available.
Anyone knows why?
The router comes with IPBASE and DATA license.
Hi,
I have a problem to connect a Juniper Firewall and our Cisco 5515x firewall.
I was given a snapshot of the Juniper Firewall config and ask to match it. Below is the Juniper Firewall config.
set interface tunnel.2 ip unnumbered interface etherne...
Hi Rick, Sorry for the confusion. The issues raised are for IPv6. IPv4 is working. 1) The configuration to advertise A.A.A.0/24 to your BGP neighbor looks right. But you tell us that"I don't see the advertised subnet when I query it from BGP Lookup t...
Hi, Even though the advertisement looks right, I don't see the advertised subnet when I query it from BGP Lookup table.I also could not ping the interface from Internet and a PC connected to this segment has no Internet access. interface GigabitEther...
Hi, I could change the Interface IP to A.A.A.1/29 after I put in the route to null0.The BGP works and I could ping the Interface from Internet.I need to subnet it further for our customer use.I will do this tonight. However, the same config applied t...
