Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need the cisco commands to get the below like output while executing the " Sh run " command in cisco router ; Can any one help me on this! Last configuration change at 20:06:55 GMT Sat Sep 29 2007 by shyue! NVRAM config last updated at 22:53:16 GM...
Dear Team,No need for any extra command for SM fiber and you can check the laster light signal visibleThanks & RegardsD.Pugalendi. Senior Consultant (Networks), TAFE Ltd.,35,Nungambakkam High Road, Chennai 34,Phone - 044-32977969 ; 9962017117
Hi Krasnoperov,You need to use the command " sh processes cpu sorted " to see the top cpu utilizerThanks & RegardsD.Pugalendi. Senior Consultant (Networks), TAFE Ltd.,35,Nungambakkam High Road, Chennai 34,Phone - 044-32977969 ; 9962017117
HiThe below command shows that the " Per packet load-sharing is disabled " so per session is working by default and if you enable per packet load sharing in the interface level then you can able to see the flow on the sh ip cef command ; try the sa...
