Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,
I have distributed ISE deployment. PAN Primary, PAN Secondary, and 8 PSN. All of them are hardware appliance.
I need to replace PAN Primary with new hardware because the old one is End-of-Sale and will be Out-of-Support soon.
I would a...
Hello experts,I have an ACI fabric and a bunch of Cisco switches connected to it. MST is configured on all these switches. We have configured a dedicated BD/EPG for the native vlan to make it work.A month ago, we got a network outage because we conn...
Hello experts,I am trying to configure per-tunnel qos feature on the HUB router (ASR1001X, IOS-XE 17.03.02). In my case, TLOC is 802.1q ethernet sub-interface.I see that the correct policy-map has been created on the HUB, but it has not been applied ...
Hello experts!I need your support to understand why the FW service is not working in my lab installation.In my lab the Bridge Domain (BD), subnet, VRF, contract and L3Out are all configured in the Tenant common while the endpoint groups (EPGs) are co...
Hello experts! I am migrating existing services from a legacy network to ACI fabric. There is an F5 load balancer that I need to migrate to the fabric. The existing F5 is one-armed and I should redirect only server-to-client traffic on it. (topology ...
Hello everyone,I found finally that such a design is not supported. It is not possible to deploy the service graph defined in common tenant in the user tenant. If you need to do so, you must import the service graph device from common tenant to user ...
Hi all, The contract scope is global. The configuration of VRF,user and service BD, redirect policy is good. I know it because everything is fine when I move the EPGs to common tenant. As tuanquangnguyen adviced, I created L4-L7 Device selection manu...
Hi Sergiu,Thank you for the quick response! I would like to clarify the configuration of the service graph for my case.If I choose one-arm option during the template creation (screen1 in the attachment) I have only one connector at the service graph ...
