Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a site-to-site VPN set up using PIX 501 and an ASA 5505. On the PIX side I would like to be able to browse the computers on the ASA side by computer name. Right now I am able to browse by IP address of the computer. Is there a setting on th...
I am set up a site-to-site vpn with an ASA 5505 at one end and a PIX 501 at the other.I followed the section titled Configuring LAN-to-LAN IPsec VPNs from the Command Line Configuration Guide and added these line to the ASA config:isakmp policy 10 au...
Our ISP has supplied us a Cisco router which is currently connected to a switch. I am trying to add a PIX 501 into the mix. Below is my current running configuration on the PIX and the router. I am not able get an outside connection when the PIX i...
Our ISP has supplied us with a Cisco router that is configured to forward email messages to the exchange server on our network. I called and told them that I am adding a firewall and they told me that they need to disable NAT on their router and tha...
I would like to add a PIX 501 Firewall to our existing network. Currently our ISP has provided a 1720 router that has a static IP address. That router is then connected to an HP Procurve switch. We already have a DHCP server in place that is provi...
I added isakmp enable outside to both devices and now I can ping and browse the systems on the 10.0.1.0 network from the PIX side.I still don't receive a response when I try to ping the ASA which is 10.0.1.1, but when I ping the other address I get a...
I've removed those three lines from the ASA and then tried pinging the ASA from the PIX and these are the response I get.PIX# ping inside 10.0.1.1 10.0.1.1 NO response received -- 1000ms 10.0.1.1 NO response received -- 1000ms 10...
This is the output from the PIX when I try to ping the ASA.PIX# sh cry isa saTotal : 1Embryonic : 1 dst src state pending created xxx.xxx.xxx.xxx yyy.yyy.yyy.y...
I've removed both of those lines from the ASA and still cannot access anything on the other side. I have talked to the ISP that the PIX is attached to and they say that incoming VPNs are not blocked. When I do the debug cry is 127 and debug cry ip ...
