I am trying to configure a Vlan (Vlan10 in my case) to work with GigabitEthernet1 interface which is connected to a Cisco LoRaGW PoE interface but i'm unable to bring it up despite trying various things.
Any help is really much appreciated.
Here...
Hi,
My IR829 router is booted into rommon-2 mode but unable to boot into IOS mode due to corrupt image(s) which always brings me back to rommon-2 mode.
Here's the output of dir command:
flash:
ir800-universalk9-bundle.SPA.156-2.T.bin
ir800-un...
Hi, I want to be able to install apps on the IR829 but i'm unable to reach the IoX local manager at https://192.168.2.2:8443 which is the Vlan1 interface.. I'm connected to the router via my laptop for initial testing to prove i can access the IoX co...
Hi, my IR829 is stuck in rommon-1 mode due to the error message
ERROR: autoboot image not valid, autoboot suspended
Listing dir doesn't show anything:
rommon-1> dir
flash:
bootstrap:
I have started a TFTP server on my laptop but I'm unable ...
How can I ssh to the guest OS from the router? Is it safe to delete some content from /software and /oldroot/software so that my new app will have sufficient disk space available?
My EFM app requires 256MB disk storage but the only available spa...
Ben, you're right on the money. How stupid of me to not checked this router properly before pulling my hair out.
Thank you for your patience and replies.
A wireless lora gateway is connected to it (https://www.cisco.com/c/en/us/products/routers/wireless-gateway-lorawan/index.html) so that the IR829 can act as a backhaul.
When I connect another router which has been running in production for few mont...
Ben, thank you for your reply. Issuing the command no autostate on the Vlan 10 interface brought it back to life.
IR829#show ip int br
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0 ...