Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, Currently running my WAP in 2.4g network, and nearly all clients associated, anre then dropping and re authenticating within a few minutes. I have set up the AP as per the best practice guide, and rolled back to 1.0.1.12 firmware but still t...
I have a WAP 571 and after setting in up etc, there doesn't seem to be any option of seeing client statistics etc, eg RSSI. I am able to find who is connected. I have also noticed there is no option to tweak any RSSI for roaming. Or am i not looking ...
Hi all,
To keep things simple (for me), i have decided to create a new interface that can be used in place of the management interface on my AP's to support guest access to the internet.
I have created a new interface, however, it keeps telling me ...
Hi all,
Just bought and set up an RV130 that replaces a Ubiquiti Edgrouter.
Having a number of issues where a number of devices are dropping from the network now.
I have configured the router with static Ip's for some of the devices.
Primarily, w...
Hi all,
I seem to have a bottleneck with my Linksys poe+ switch, so i am looking at replacing it with the
Cisco SG110-16HP
However, looking at the spec, it seems that it only support POE (af) and does not support POE+ (at)?.
Is this really the ca...
Ok,back on this.
I have now done as suggested and mapped Port 2 on vlana.
I have connected port2 on the 2504 to my network switch.
I now have a wifi network that i can join, and it is not showing any other devices on the network that can be discov...
Hi Scott,
Long story short, i want to create a separate WLAN for wireless clients that would only have access to the internet and nothing on the local network.
Hopefully with that, i can create and use an independent ACL that would allow this.
I c...
