Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,am using FBR 1010 to Configure AnyConnect Remote Access, on my test lap i used 192.168.1.0/24 as outside, and 5.5.5.0/24 as Inside, FW IP is 5.5.5.1 and outside VPN IP is 192.168.1.111i connected VPN Client and i can access internet but i can n...
Hello,I have Cisco FPR 1010 and am using AnyConnect V.4, when i connect from outside the Tunnel is up but i can not access Remote Subnet (Network Behind Inside Interface), I have VPN Pool 10.10.10.0/24 and the Remote Inside Subnet is 192.168.1.0/24,...
when i configure outside interface with static ip i can not access internet through inside interface, but when i change it to DHCP i can access internet, Polices and NAT rules are Default, is there any additional Configuration need to be applied ?
Hello Cisco Community, i have an issue with Cisco AnyConnect, when Connect to Anyconnect it disconnect my internet, i tried to configure split tunneling but same issue happenedConfiguration Posted below,Kindly Need HelpASA Version 9.8(2)!hostname Hor...
Helli RJI,Thanks For youe Reply, Kindly can you check update rules below, i have changed as you mentioned, but no things changed, am still can not ping to remote inside lan
show vpn-sessiondb detail anyconnect> show vpn-sessiondb detail anyconnectSession Type: AnyConnect DetailedUsername : user Index : 3Assigned IP : 10.10.10.1 Public IP : 192.168.3.61Protocol : AnyConnect-Parent SSL-TunnelLicense : AnyConnect PremiumEn...
i do show nat detail from cli and here is output> show nat detailManual NAT Policies (Section 1)1 (outside) to (outside) source static VPNPool VPNPool destination static InsideNetwork InsideNetworktranslate_hits = 0, untranslate_hits = 0Source - Orig...
