Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greeting we’ve 3X UCS 5108 chases connected to twoCisco MDS 9148 SAN Switch (VSAN #2) with one EMC VNX2 storage. (diagram attached is similar to ours).In this setup all blades boot from the SAN. (ESXI, Hyber-V, XenServer)now we decided to replace the...
Hello,HiI recently build new setup for UCS 5108 chases with 2x blade servers ( B200 M5)using two Cisco UCS 6332 16UP FI connected to Brocade SAN Switch with one Netapp af220 storage FC mode (as show in this diagram). In this setup blades boot fro...
Hello,
Currently we’ve 3X UCS 5108 chases configured in HA with full blades mix (B200 M2, B230 M1) using two 6296 UCS Fabric interconnect connected to two Cisco MDS 9148 SAN Switch (VSAN #2) with one EMC VNX2 storage. (diagram attached is similar t...
thank you ...I've spent time to find a reason + to solve it, and did not find anything , I did not expect need to activate first from KVM and then appear automatically. thanks again
thank you for your replay
Currently I have three scenarios
1. assuming not have enough ports in between FI & MDS for uplink. since we use 6ports on FC1 and 6ports FC2 Is there a risk to use the same current uplink ports. and the current utiliza...
