About StewieGriffin

StewieGriffin · 03-05-2015

Hello,Trying to download running config from x20 routers as batch job using Prime 2.2.Actually I need to run the following commands using Prime's user-defined CLI template:#copy running-config tftp:Address or name of remote host []? 1.2.3.4Destinatio...

StewieGriffin · 02-26-2015

Hello, CUCM 9.x.Could you please advice me the CLI sql query to get registered MGCP endpoints IP addresses? Thank you in advance.

StewieGriffin · 02-10-2015

Hello,Scheme:Cisco SCCP-based IP Phone > CUCM 9.1 w/ SIP Trunk > CUBE (28XX, 151-4.M7) > SIP ITSPCUCM Active Call Proc. Node IP: 10.10.10.9CUBE Inside Interface IP: 10.10.10.10CUBE Outside Interface IP: 20.20.20.20Cisco IP Phone: 10.10.10.8ITSP SBC I...

StewieGriffin · 02-10-2015

Hello,Scheme:Cisco SCCP-based IP Phone > CUCM 9.1 w/ SIP Trunk > CUBE (28XX, 151-4.M7) > SIP ITSPCUCM Active Call Proc. Node IP: 10.10.10.9CUBE Inside Interface IP: 10.10.10.10CUBE Outside Interface IP: 20.20.20.20Cisco IP Phone: 10.10.10.8ITSP SBC I...

StewieGriffin · 02-10-2015

Hello,Scheme:Cisco SCCP-based IP Phone > CUCM 9.1 w/ SIP Trunk > CUBE (28XX, 151-4.M7) > SIP ITSPCUCM Active Call Proc. Node IP: 10.10.10.9CUBE Inside Interface IP: 10.10.10.10CUBE Outside Interface IP: 20.20.20.20ITSP SBC IP: 30.30.30.30ITSP SIP dom...

StewieGriffin · 03-05-2015

Up

StewieGriffin · 03-02-2015

Hello,I've managed to do memory upgrade recently from 256 to 512 for this specific ISR 2851I've done IOS change also then from 124-24.T8 to 151-4.M9.Unfortunately all symptoms persist: again & again using 'debug mgcp packets'output I see DTMF digits ...

StewieGriffin · 03-02-2015

Hello, I've managed to do memory upgrade recently from 256 to 512 for this specific ISR 2851I've done IOS change also then from 124-24.T8 to 151-4.M9.Unfortunately all symptoms persist: again & again using 'debug mgcp packets'output I see DTMF digit...

StewieGriffin · 02-26-2015

Manish,It shows only the following fields:typenamedescriptiondevice_poolI need the table with this data:nameip address

StewieGriffin · 02-16-2015

Ayodeji,After I've checked 'Media Termination Point Required' under CUCM's CUBE trunk all is working.The only strange things are the following:1. I do not have CUBE XCD registered with CUCM, only with itself. I mean CUCM theoretically cannot access ...

Member Since	‎07-02-2009 01:19 AM
Date Last Visited	‎08-18-2017 06:45 PM
Posts	32

User Statistics

User Activity

Prime - Batch job to download running-cfg from group of routers

CUCM SQL Query - MGCP EPs IP Addresses

CUBE - New Deployment Issue - No media after HoldResume

CUBE - New Deployment Issue - Not working DTMF Relay

CUBE - New Deployment Issue - Cancel local RBT

Up

Hello,I've managed to do

Hello, I've managed to do

Manish,It shows only the

Ayodeji,After I've checked