Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am facing some issue with bluecoat for caching. When i do the WCCP configuration on normal switch it works fine. Users can access the internet but when i configure WCCP on ASA the i can't see any traffic redirected. Details are as follows:Physic...
Hi,I am facing some issue with bluecoat for caching. When i do the WCCP configuration on normal switch it works fine. Users can access the internet but when i configure WCCP on ASA the i can't see any traffic redirected. Details are as follows:Physic...
I have installed the 7600-SIP-200 and SPA-4XT-SERIAL modules in the 6513 switch. Both modules have been detected. But, I received following error message:“SLOT 1: 00:00:04: %SPA_OIR-3-UNSUPPORTED: The SPA-4XT-SERIAL in Subslot 0 is not supported by t...
I have installed the 7600-SIP-200 and SPA-4XT-SERIAL modules in the 6513 switch. Both modules have been detected. But, I received following error message:“SLOT 1: 00:00:04: %SPA_OIR-3-UNSUPPORTED: The SPA-4XT-SERIAL in Subslot 0 is not supported by t...
With call manager 4.1 sometimes the users can't call an international number and at the same time when someone calls from outside to inside the get "Network Congestion" message. To resolve this issue whenever i restart the call manager it resolves th...
Actually that was a typing error. Bluecoat IP is 10.57.56.7 and ASA IP is 10.57.56.1(Bluecoat's and users gateway is ASA IP and there is where i had configured WCCP but it's not working
Hi,I did group 0 configuration but it's not responding. The configs are as follows:AT-INET-FW# sh run wccpwccp 0wccp interface WIRELESS 0 redirect inAT-INET-FW# show wccp 0Global WCCP information: Router information: Router Identifier: ...
I will try that but there are going to be around 70 different VLANs(sub interfaces on ASA firewalls) and they shouldn't communicate with each other. This means i have to create 70 WCCP statements for each vlan on ASA right?
