Hi everyone, I am trying to set up priority queuing on ASA to prioritize voice traffic within my network but I cannot figure out what values should be put for queue-limit and tx-ring-limit. I read the below documentation but still cannot figure out h...
Hi, I have WLC + Lightweight APs running in my office which has one single SSID for 2.4Ghz and 5Ghz spectrum.My laptop's wireless adapter supports up to 802.11ac. I would like to know how my Windows laptop choose which radio frequency's SSID to conne...
Hello, I am having this issue that Ipsec VPN re-keying between ASA5525 and MX68 sometimes fails. This issue happens about once a week.workaround for the issue is clearing ikev1 sa and ipsec sa but I would like to know the root cause of this issue. I ...
Hi everyone, I would like to know what would be the impacts of adding many subnets to crypto map ACLs for Site-to-site VPN. Currently HQ and new branch office is connected with IPsec site-to-site VPN over internet.I would like New branch to have acce...
Hello, I am having a problem with IPsec VPN on ASA5525. the issue is that even IPsec tunnel has been established, traffic from HQ (ASA5525) does not flow through ASA outside interface.It seems that traffic from branch(Meraki) can go through HQ ASA an...
Hi GRANT3779, Thanks for your reply. That is good to hear that there is no real impact.I am running an ASA at HQ and Meraki MX68 at NewBranch. Basically ikev1 IPsec vpn is the only choice. Thanks,Tats
Hi Lyle, Thanks for your reply. No we have not considered DMVPN as I am quite new to network stuff and do not know much about DMVPN. Also we are using Meraki MX68 at NewBranch and I saw MX68 only support ikev1 IPsec VPN only with non-Meraki device in...
Hi Francesco, Thanks for your reply.I cannot post the result of command but the below command's result was all ALLOW. I would like to set up VPN on "outside" interface which is my secondary internet connection. Thank you.
