Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys i am new to the cisco world.I am trying to configure SDM 2.5 on a cisco 2600.I have access via telnet to the router and was able to change the enable password - which i think is level 15 (right?) and setup (and bring up) the ip on the ethernet i...
Below is the last Show run, i can't connect via https.i was unable to complete: ip http secure-serverjust didn't work apperantly crypto isn't available on this router.i can http into the router using a browser.Current configuration : 754 bytes!versi...
No i was unable to get SDM to runit is asking for SSH and Telnet user name and password, and it is not the same as the user 15 i assigned.so sdm didn't let me get in.
