Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Helle everyone,
I have the Handlink WG606 which is basically a Hotspot router configured to use CISCO APs with controller 2504, interface is directed to 10.10.13.254 (Handlink), all was working fine, till system shutdown and rebooted, then all users ...
our company (https://syber-technology.com) is based in Beirut, Lebanon, with the huge chaos now happening in terms of power shortage, we had to switch to solar energy to apply multi layer of power sources just to stay online, after inserting a power...
hi there , Thanks for the reply,. I have configured port 22 (server) as interface GigabitEthernet1/0/22switchport trunk encapsulation dot1qswitchport trunk allowed vlan 51-54switchport mode trunk no ping and no access from Vlan51-54.Am I missing some...
Hello everyone, I know this is a bit old blog, but I hope if someone could help! I have 4 VLANs (51,52,53,54) , I have set a port 22 (server port) as Trunk as per the below : c3550(config)#int Gi1/0/22c3550(config-if)#switchport trunk encapsulation d...
hi there, I had 3750G and 2960L, I have set encap to ISL in the 3750 , if 2960 do not support ISL, then Trunking would work between the 2 switches ?Thanks for replying.
Hello George, Thanks for the reply!
I have access to Handlink Management interface, I did a reset, and configured it all over again,same issue!
The problem is not in the Handlink itself, it's when you connect through the CISCO WIFI, the handlink forw...
