Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We did it the first time: Multi VLAN WLAN bridge with standart Meraki MR accesspoints. You need to make a case at Meraki because the Meraki supporters need to make a change on the config. But now it works. Cool. 2 * CW9163E (it´s also working with ...
Hello,I am encountering the following problem for a few weeks. Meraki MR46 and MR46E (firmware MR 31.1.5.1) accesspoints go suddenly offline and sometimes I can get them up when I shut the switchport and then enble it after a minute. sometimes the ac...
Hello, I can use a organization wide Cisco ISE radius server for MS Switchports but not for MR accesspoints. But I would need this. Is there any timeline when this will be implemented?
I have a few MS130-8X switches and they are causing UDLD-errors at the port of the connected switch. Anybody here with the same issue? The uplink goes to an MS120 switch. The MS120 reports UDLD error on the port where the MS130 is connected.
Is there an Cisco Maerki trade in for the old devices? Or can I spend the old devices to schools and Cisco gives some licences for free? Any other option to prevent the old running devices from trash bin?
