Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have accidentally lost record of the admin password for a UC500, and I am unable to reset the admin password through the console - apparently No Password-Recovery (http://goo.gl/CtEwW) is enabled:line con 0 no modem enableDo I have any recovery op...
I am trying provision a new SPA504G phone with a UC520. Existing phones work, but were likely configured in a staging facility prior to deployment. The new phone will not boot completely - the display on the phone cycles between the following message...
Hello,On two occasions, while on the phone with Cisco support (I can't recall whether it was TAC or SBS, I've been speaking with both), I was informed that beginning this January 2011, the only supported method for configuration changes would be the ...
Hello,I have connected to a UC500 using the Cisco CA, and expect to see a set of Cisco small business phones (SPA504G sets), however I am not seeing the phones. The phones are routable, I can ping them from the workstation from which I'm connected wi...
[Below statement revised to reflect correction.]This policy apparently varies between UC500 devices. Devices supported by TAC (UC520) will continue to be supported regardless of whether they were configured by CCA or CLI; devices supported by SBSC (U...
