Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
two site connected with E1.My question is in Remote site,with only 262 packets input,how can it have a 4325 input packets error.What is the problem?What should I deal with it?Remote site using show command :serial0/1 is up, line protocol is up Hard...
It seems the dialed numbers after transmitting from PBX to csico 2600 router's FXS port become wrong. I dialed '191',then after router receives it become '119',what happened ? It seems the number '1' get doubled in PBX or FXS ?
two telephone set are here:one in remote office with phone number '191',the other in central office with phone number'192'.Problem: When I dial in remote office to central office using phone number '192',the telephone does not answer,but if I chan...
I went to the IEEE homepage,but I can't open the standard drafts I am looking for.I have no permission.I want to get the raw materials or specifications about 802.3 or 802.11 .Help.
Here is the whole configuration: ( maybe a little long)Thanks !version 12.0service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname jwzgs!enable password hxxhxx!ip subnet-zero!voice-port 1/0/0!voice-port 1/1...
NO need of VLAN or any other solutions.ip access-lists wiil ok.At central (7200)Department 1 ip addr x.x.x.1 to x.x.x.14Department 2 ip addr x.x.x.15 to x.x.x.28............At branch(2600)department 1 ip addr y.y.y.1 to y.y.y.14department 2 ip add...
