Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all,my question:i have a 100Mb/s Link with a Delay of about 15 ms.There is a Lotus Notes Client-Server communication running and i am not able to fill up this connection because of delay and windowsize of notes.does anybody know if there is a k...
hi,i have (perhaps) a silly question:we have a enddevice which connects over a serial cable to a routers serial interface (enc x25).the problem is, that the cable between has no pin 20 (dtr) and so the connection does not work because the router need...
hi,if i have a gigabit ethernet wirh for example 10 vlans - one native vlan and 9 802.1q tagged vlan, is it possible, that cdp pakets are forwadet on all subinterfaces (vlans) and not only over the native vlan ?this means i need the cdp information ...
hi,we have a central 7606 encsyptionrouter, which does encryption for our branches.the traffic is marked with dscp bits and the encr-router copies the inner dscp value to the tunnelheader - thats ok.but in the way from the central ip-sec(7606) route...
hi,i have routers, which have ip-sec tunnels.now i want, that the router copies the original ip-prec or dscp value from the original ip packet to the layer 3 header of the ip-sec-packet.the reason is that routers inbetween should be able to recognize...
Hi,thank you for your answer.Yes it uses TCP.I think i do not have problems with the TCP-Windowsize.Is it possible, that e.g notes for itself uses a kind of blocksize, which is independent from tcp-winsize and is smaller and so the whole communicatio...
the thing is, that i have a self-made cable between the routers v24 dce-cable and the cashing machine.in this self made cable i have no pin 20 which is wired.i have this szenario over 300 times, and it would be very comfortable if i could disable tha...
Sorry we mixed up the routers.The correct interface is:Interface Serial0/1Hardware is PowerQUICC MPC860DCE V.24 (RS-232), clock rate 19200idb at 0x82A6E298, driver data structure at 0x82A7602CSCC Registers:Do you have any further ideas?
hi,thanks for answer - this would be exactly that, what i want and need - BUT:!r-altmuen1#sh controllers Serial0/0/0Interface Serial0/0/0Hardware is GT96KDCE V.11 (X.21), clock rate 64000idb at 0x456ECCF8, driver data structure at 0x456F4414wic_info ...
hi thanks for answer,we found the reason:we have a 48 port gig card (layer2) in the 7606 - and there we have to configure "mls qos trust dscp" because the switchengine rewrited our pakets !!