Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are moving from a pix to an asaOur current pix implementation looks like thisstatic (inside,outside) 5.5.5.5 1.1.1.1 255.255.255.255static (inside,outside) 6.6.6.6 1.1.1.1 255.255.255.255When I try to do this on the asa I can only do a single inst...
HelloI was wondering what the default vlan was for the fastethernet0 port on the back of the WS-C3750E-24TD. I was hoping to use this for simple web management, but would like to use it for some of my vlan1 work as well.
One of my interfaces is showing this:#sh standby GigabitEthernet0/1 - Group 20 State is Init (interface down) Virtual IP address is 10.1.28.1This system RouterA) is IP's with .2 as its IP and .1 as the standby.It partner - ROuterB is .3 with .1 as ...
If I have HSRP set up correctly - should I see requests coming from those routers only from the HSRP address?Example router1: 10.10.10.1router2: 10.10.10.2HSRP 10.10.10.3If a router makes a request* - will it come from the 10.10.10.3 address? I woul...
Can I assign multiple IP addresses to the same interface?example _ I have about 5 /30 subnets that are plugged into a switch. Can I assign the gateway IP address for each of those subnets to my router so that it can the the gateway device for each s...
I think I found my own answer:"The simple answer is yes, but you can't using the "static" command as you would expect or else you'll get the error "ERROR: duplicate of existing static".So the following configuration will fail;static (Inside,Outside) ...
did it.now I get this message:crypto_isakmp_process_block:src:5.5.5.5, dest:10.0.32.10 spt:500 dpt:500OAK_MM exchangeISAKMP (0): processing SA payload. message ID = 0ISAKMP (0): Checking ISAKMP transform 1 against priority 1 policyISAKMP: encryp...
