Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hii want to connect a Server to my Switch. This Server has a NIC with 2 Ports. Both ports seem to have the same MAC Adress. The Server will send its traffic balanced over both Ports of its NIC which is connected to 2 Ports of my switch.At the moment ...
HiI have two Switches (4948) i want to connect via 2 GigabitEthernet Ports. The two Ports should build a Channel and forward all VLANs.Heres the config i enterd on both switches:!interface Port-channel1 switchport!interface GigabitEthernet1/47 switch...
HiCan someone explain the function of the "Aironet DDP" protocol?!Will i have to enable Aironet Extension on a accesspoint, if the client is sending such protocol?
HelloWe've some Cisco 1100 and 1200 Accesspoints and heard about the Wireless Domain Services.We'd like to use this Service to reduce the roaming-time. I already read the configuration guide but there's something i didn't understand.Do i have to inst...
HiI've got a 3640 Router with one 1FE 2W module in bay 3. Each time i start the router, following message appears:%PA-2-UNDEFPA: Undefined Port Adaptor type 215 in bay 3The whole 1FE 2W interface doesn't work on that router. But what does this messag...
Thank you for the answer.That's i wanted to know.So a radius server is needed, but no external if we have an IOS based AP with integrated radius server.We have a customer that is using hand-held scanners and the integrated antennas are scanning very ...
