Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just had a Polycom VSX 5000 dropped on my desk and told to configure it. I have no clue as to what I am doing in regards to video and can't seem to find any information on what to do.If anybody can point me in the right direction that would b...
Running Callmanager 3.3 and Unity 4.When an external call comes in the greeting is played. When an extension number is entered to be transfered to the anouncement is played "please wait and I will transfer you".However the call imediatly goes to the...
Thanks.I did that but the call manager can still not see it. Do you know of a location of any good documentation in regards to setting up the gatekeeper etc.I also need it to connect to ISDN trunks connected to a 3745. Any hints as to what I need e...
When the CallManager voicemail ports were configured the first Port was setup to be the pilot and put it in a VM Pilot Partition. On busy it was set to hunt to the next port etc etc. The next 49 Ports were set in a different partition. The next 30...
No I have already checked that and yes the system is a new install.I have been a Repartee admin for years and though unity is new to me I have been around long enough to check most of the simple things. I have spent a few hours going through these f...
