Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I hope someone can shed some light on what is happening here. I Have a CME setup with a SIP trunk like this: IP Phone --> CME --> SIP ProviderI have a delay for outgoing calls that i can't seem to find what is going wrong- Sometimes its ...
So i had incoming calls work before with a test number received from the provider. Today they changed the number on their end to what it's suppose to be and incoming calls are now failing with message 500 internal server error and cause 16. Why is t...
Hi ,
When i make an outbound call there is a delay of 25 secs. Inbound calls are instant.
this is the scenario IP Phone --> CME --> SIP Provider
dial-peers are very simple yet i still get a delay.
attached debug voip dialpeer inout and dial-peers...
Hi Anthony,Sorry for the delayed response, but i found the problem thanks to your advice.I needed to add ip host _sip._udp.avayapbx.telesur.sr srv 1 50 5060 avayapbx.telesur.sr to the config. Calls have been instant ever since.Regards,Ivan
Hi Anthony,getting the following response. Also attached the debug logs. ICT-CUST-BNETS-VGW#ping _sip._udp.avayapbx.telesur.srTranslating "_sip._udp.avayapbx.telesur.sr"...domain server (255.255.255.255)% Unrecognized host or address, or protocol not...
attached the log.
i have added the translation rule to the dial-peer . the call is still failing
dial-peer voice 2 voip description ** Incoming dialpeer sip-trunk calls ** translation-profile incoming INCOMING-CALLS session protocol sipv2 session t...
will apply and test again. Just got notified that the provider switched the number back to analog so will have to wait until they put the number back on the sip trunk.You are right it was overlapping but oddly enough i had no problems before.
