Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of my customers is connected to my backbone by use of two 828 devices having a line of 1 Mbps in between. My backbone is running Mpls and I am trying to apply QoS for voice on these 828's. I tried priority queueing. Though the configuration looks...
Hi all!We created two VLANs namely VLAN1 (on Dot11Radio 0.1 and Fastethernet0.1 which is native VLAN)and VLAN2 (on Dot11Radio 0.2). We gave ip addresses on Dot11radio0.2 and Fastethernet 0.1 which are in different subnets. We can not reach the Dot11r...
Hi!I have a 2950 switch with two gigabit and 24 Fastethernet ports. I am trying to reach a capacity of 200 Mbps by using etherchannel between the switch and the router. Two FE ports both at the switch and router sides are included in the etherchannel...
Dear Martin;Thanks for your reply.The customer has their voice boxes at these ip's. So all the traffic flowing through these ip's contain voice packets.I am now trying to mark the "dcsp ef" bit at the entrance (ethernet) and then after catching them ...
Thanks for your answer.After a couple of tries we solved the problem with some other configuration that we did not want to apply. We configured the clients (dot11radio interface) operating as a workgroup-bridge and on the root side we wrote the line:...
