Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2811 that I’m getting some odd behavior from. Just to be clear the startup config is blank and the only file on the flash is the IOS image"c2800nm-advipservicesk9-mz.150-1.M10.bin". If I connect it to my network via F0/0 and turn it on ill...
I’m looking for a way to explicitly allow certain VLANS to be routable. In this example I would like VLAN 25&35 to talk but 25 cannot communicate with another vlans. I would like to apply the rule to VLAN 35 that way I don’t have to remember to do ...
I've been fighing this all day and im going in circles. I have a block of static ip addresses "xxx.yyy.56.104/29. i dont know if it matters but im using a single subinterface for everything other than asdm. if it is important that can change. the...
Rather than scrounging around the internet for a Linux client I use the networkmanager open connect client. This not only provides VPN capabilities with Cisco but a nice assortment of other vendors. Here is the link to the arch linux wiki:https://w...
The class c address is offered by the CPE provided from AT&T. The 2811 is a client and is grabbing an inside global address of the CPE. The only other DHCP servers are isolated behind another router and shouldn’t be advertised on this segment. This i...
Thank you for your help. I did correct the error with the wildcard masks. Would having those miss configured wildcards have any effect on efficacy of the ALC rules, since in this case I’m not using any of the other subnets of 10.10.35.x. Also I st...
I believe I found the error. The ACL is in the incorrect order. As I am still learning what would the easiest way of fixing this. the complete config is on my google drive.!ip nat inside source list 1 interface GigabitEthernet0/0.666 overloadip ro...
