Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a single AnyConnect user who has reported random disconnects so I have gone through all the checks I can make and looking at the logs I see the reason for the disconnect appears to be 'Loss of the network interface used for the VPN connection....
I have a user who needs a report of their web browsing traffic for the past 6 months and when I ran a report it appears that traffic was only being allowed from just over month ago and all logs prior to that show just blocked traffic.We know the user...
Hi, I would only advise that you use the GUI or the FMC to upgrade firepower but if you are adamant on using the CLI then you could consider re-imaging the sensor to version 6.2 as that will be quicker and avoid the intermediate upgrades needed for t...
OK @Sheraz.Salim thanks we will try that out.So to confirm that reason code 8 indicates a software issue and not a local connectivity issue is that right?Also would anyone know if there anywhere online that lists these codes and reasons with explanat...
It is also worth bearing in mind that each Access Control policy has a setting in the Advanced tab for 'Intrusion Policy used before Access Control rule is determined' where packets are sent through this policy using the default variable set before a...
Thanks for the prompt response.Looking at the link you have provided it does mention that customers can retain the data to match the terms of their subscription which I need to check, as I mentioned I am sure I have seen logs older than 45 days in th...
If you have defined the variable set correctly it is possible you have not defined the internal networks in the Network Discovery policy.
Goto : Policies > Network Discovery and define the internal networks you would like discover. It defaults to 'an...
