Why would you need to convert a fiber to coax? I assume the provider delivers these speeds on fiber; to interconnect you would need an atm interface?Bettr check with them.

Hi,If the two switches are connected over a cat5 cable, did you use a crosscable?hthpaul

Hi,Are you using the same trunk type (802.1q or isl) on both sides of each trunk?hthregardspaul

Hi,Netflow V5 comes from the L3 engine, while V7 exports from the L2 engine. You will need to create both to be able to see all traffic processed by the switch.On top, for the L3 traffic to be seen, you will need the ip route-cache flow statement in ...

Hi,Quickest result if you install a Debian box, install flow-tools and configure it to listen to your 20 routers.See www.splintered.net/sw/flow-toolshthpaul