Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,One basic question to you about bandwidth utilization measurement of ATM links !!We are using the MRTG to measure bandwidth Utilization of all our WAN links, and in all cases we could see the utilization growing upto 100% in peak time except o...
Hi,I have Cw2k with RME 3.4 of RWAN installed on Windows platform. Even though the devices are sending NTP synchronised syslog messages (with correct time) to Cisco Works server, the Syslog analzer results shows permanant 6 hour time lag from the act...
Hi,I would like to install IPM v2.4 on win2K SP4 though CISCO recommends to do on SP2. This is because our corporate policy does not allow me to keep any machine with SP2 on live network. Is there any solution to do this?? While I am installing on SP...
HiUse the attached tool,It does the same thing as tail does in Solaris. But the problem is, this tool works only on Windows XP. So to get the "tail" of Syslog_info (assumes that CW2K is installed in Win2K server), map the drive of CW2k (where syslog ...
HIMake sure that new IP addresses are part of IP ranges defined in the ANI discovery settings, Server Config --> Setup --> ANI Server Admin --> discovery settingsB RgdsHabeeb
I didn't try any other tools, but I am expecting the same result with all tools, because all these tools measures the in/out octect rates given by the SNMP MIBs.Thanks
Hi Dave,My problem is still unresolved, as suggested by the local Cisco Support I do updated with all patches & updates of this version of RME, but no luck.To get the root cause of this problem, I installed the same version on a similiar OS environme...
