Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a 3640 router running IOS 12.2. I am trying to use NBAR and QOS to block or tone down Kazaa2 traffic. I have the kazaa2 pdlm loaded into my config correctly and it shows up in the list when I do a ' show ip nbar protocol-discovery'. When I t...
I'm trying to setup a site to site VPN connection between our corp office PIX and a remote Windows 2000 RRAS server. If I'm using the command:ip local pool bigpool 192.168.35.1-192.168.35.50and a Windows 2000 RRAS PPTP connection picked up the addres...
I have a PIX 525 running PIX 6.01. I'm trying to setup a SuperScout email filtering server to scan for viruses and such. I had a static address translation from the public IP address of our mailserver to the actual private IP address of the server. I...
Is there a way to create a pool or group of non-contiguous "inside" addresses to use in acl's. So you don't have hundreds of acl's to deny outbound traffic? Say you want to deny a third of your network from accessing AOL IM on port 5190 without havin...
"1. The command “match protocol kazaa2 file-transfer *” might miss some of the data flows being tagged as file-transfer but will be classified as kazaa2, due to a corner case. For absolute control over direction of the file transfers, you must upg...
I'm having the same problem with Kazaa2 traffic not being detected even with the kazaa.pdlm loaded. Have you had any luck yet? If so, what might I be missing?
You can use the PIX PDM software. It's a GUI that requires PIX 6.0. Go to http://www.cisco.com/cgi-bin/tablebuild.pl/pix to get the software. Note, the PDM is great for basic configuring and monitoring but lacking in features such as VPN setup and ma...
