I would like run SAA for jitter measures over Internet, but for do it is necessary a rtr-responder... so I’m looking for publics rtr-responders in main networksSomeone know any public rtr-responder?ThanksMatias.-
These parameters that defines your SLA can be measured via SAA. In fact, you can run several 'SAA instances' in order to get delay,jitter,pkloss,etc for each class of service. The result of these tests can be taken via SNMP from you management system...
Scott, regarding your original question, FQ must be disable in links greater than 2M because FQ identify all flows and assign an individual queue to each one. After that FQ assign high priority to low traffic flows.The issue is: when you have high-sp...
Probably your configuration is too large to be stored in nvram. Enable 'service compress-config' and then try again to 'copy runn start'.Good luckMatias.-
Problem is related with your full routing peer. So I suggest you enable BGP dampening. Also to prevent BGP peers flapping disable fast fallover. Include these commands in your BGP configuration:no bgp fast-external-falloverbgp dampeningGood luckMatia...
