Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I am wondering if anyone has recently done an upgrade on PIX from 6.2.2 to 6.3.x and found any issues. Also, I am interested to know which subrelease in 6.3 train is more stable? Would that be an issue if I put 6.3.x on old 520s?I ap...
Hello all,I would like to know if I change timeouts on PIX firewall, do I just need "clear xlate" to bring them into effect or something else is required.TIA.AS
Hello all,I am trying to understand the relationship between number of active/idle connections and memory utilization in PIX firewall. The PIX under consideration is 520 running 6.2.2 software on it. How much memory PIX uses per active vs idle connec...
Hello all, I would like to know if I can configure static commands with overlapping addresses and it works. For e.g. if I have an address that is already covered in a net static statement like: static (inside,outside) 192.168.10.0 192.168.10.0 netm...
How redundancy can be achieved with IDSM-2 blades installed in one or more switches. I have looked at the Cisco documents but could not find much on IDSM-2 redundancy features.
No its not typo because I want to specify the number of connections that this host can open at one time. However, I have tested it by changing the sequence and it worked for me.So thanks for all your suggestions and help.
Thanks Nadeem.Is the other IDSM required to be in the same Switch or it can be in other switch. What I am trying to understand is various level of redundancies that can be achieved with IDSM-2. In case if I have Switch A and B at one site for the p...
