Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have problem with my Cat. 3350. It cannot boot up and it fail at the POST.Here is the error message as below.Unexpected exception to CPUvector 700, PC = 0 -Traceback= === Flushing messages (00:00:13 UTC Mon Mar 1 1993) ===Buffered mess...
Hello,i have one ASA5520 which is using 3 GigabitEthernet Interfaces.1- Outside Interface2- Inside Interface3- DMZ Interface The outside interface is using for Internet connection which connect to a Internet gateway router.The inside interface is us...
Hello All,Thanks so much for help. I am planing to migrate this vpn end of this week. Any problem, i will get back to you again.Thanks.Best Regards,Vin
Hello Sean,Your above sample is to configuration Vlan2 for sub interface, so now i have vlan3 config as you see in my previous post. So can you tell me how to configure that?Please note: The interface configuration on the pix are the existing Pix 515...
Hello,Thanks for your reply. I think my question is a bit confusing. Anyway I have done the vpn configuration (L2L) and it works fine. But my question is it possible to config both local network are in the same network range? 192.168.2.0/24>>>cvpn_BO...