Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to get a PCM352 with firmware 42530 working on a Compulab i686 PC/104 system. The PC/104 system runs a version of Red Hat 7.0 that doesn't include gcc or Perl. It looks like I need to compile the driver on a PC and transfer it to the i686.Aft...
I need to configure a Cisco ATA-186 to receive an H.323 call from Microsoft NetMeeting. I've configured Netmeeting according to the instructions in the "Netmeeting - IOS" guide, but I need some tips on configuring the ATA-186 to receive Netmeeting ca...
We're attempting to set up a tunnel to allow http traffic between two LANs via an IPSEC tunnel. Unfortunately, the tunnel only comes up when I select "network autodiscovery" routing under the lan-to-lan connection. I would prefer to simply use netwo...
Although my tunnel is showing as "up", I'm getting this debug result when I tracert to the peer at teh other end:(Note that the source interface for the traceroute and ping is showing as my "private" interface.10395 01/04/2005 11:44:52.480 SEV=7 IPSE...
Since I only have access to the VPN concentrator, here are the results of the debug I was able to run.8801 01/04/2005 08:03:40.270 SEV=7 IPSECDBG/1 RPT=2712 Could not find assigned address for tunnel!8802 01/04/2005 08:03:43.250 SEV=7 IPSECDBG/10 RPT...
