Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have just recover my c2960 switch uploading IOS by xmodem. During the orocedure I changed the baud rate to 115200 to make faster, and now I am not able to change it. I tried unset BAUD, set BAUD 9600... anytime I reboot the switch is again with ...
I had this problem after upgrade from LMS 3.1 to 3.2 and I solved it by restarting processes with this at the command line:net stop crmdmgtdnet start crmdmgtd
It works.This is what I did:-shutdown the switch-press Mode button while power on the switch to enter in switch: mode.-enter set command to see the BAUD=115200-enter flash_init command-now is the right moment to enter unset BAUD command-continue bo...
I have another 2960 with the same path and everithing goes correct.Anyway I tried by changing the path to flash:c2960-lanbase-mz.122-2-25.SEE3.binand the problem persists. The load of the image is normal but I still can't change the console baud rate...
Hi,Yes I know what you mean I have use those values with other models for password recovery, but in this case the config register is 0xF which is normal in this model as I has been reading. You can see the show version in the answer I wrote before to...
Hi Glen,As you can see config register is 0xF. I hadn't change it, this is the factory value.Switch#show versionCisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(25)FX, RELEASE SOFTWARE (fc1)Copyright (c) 1986-2005 by Cisco Systems, ...
