Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can I setup a bridge as a transport bridge between two bridges as following?LAN1---B1---B2---B3---LAN2____________\_____________\______________\B4---LAN3How should I setup for root and non-root in this case?Can I do aggregation if I have 2 bridges in...
Is there any way to use extended ACL for EIGRP offset list?Other than policy routing, we want to use offset list to control only specific source and destination takes the backup link.
Here is the PNNI topology from one of the ASP:USKEN15DRASP#sh atm pnni topology node 13Node 13 (name: USUNI13DRASP, type: LS1015, ios-version: 12.0)Node ID..: 56:160:47.009181000000009086003401.009086003401.00Node AESA: 47.00918100000000908600...
Here is the lay out: --R2--E1---R1---E2/ \E3 \ / --R3--I have added delay for R2's E2 interface, but when I check the EIGRP topology from R1 for E3, the metric didn't change and they are still the same for...
Our core router is showing more than 90% of CPU utilization and the SNMP Engine is taking more than 70% of the CPU cycle; I have gotten a Sniffer trace but from the core subnet, not really a lot from our NMS.How can I find out the source for driving ...
Here are some details...We have 2 VLANs between LAN core router and WAN router, they are doing load balance and backup.We want to setup traffic from one particular site to server VLAN behind the LAN core router only takes VLAN 1 for said and use VLAN...
OK... I need to enable the Background Routes in order to see the physical link it takes, but after I setup the Link Selection, it is still showing the alternate link as first choose as following, what did I do wrong?USUNI13DRASP#sh run int atm 12/1/0...
The map was messed up... Try this one:E1---R1---E2---R2---E3____________\--R3--/Basiclly, R1 has 2 same size conection to R2 and R3 and both R2 and R3 connect to E3.Where should I add the delay to have R1 perfer R3 for E3?
I am seeing from one of our vendor managed router as following:SP_Mexico>sh int s0/0Serial0/0 is up, line protocol is up Hardware is PowerQUICC Serial Description: 2M port to MCI IFRS/PIP Cloud, CID: W0F30037 (12/9/2004) MTU 1500 bytes, BW 1984 K...
