Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I have an MPLS SR with two PE router.I have on this 2 PE Routeur the same L3VPN VRF.On one PE router, on the VRF i have two peering and i receiving the same prefix 1.1.1.1/32 coming from two peering from two the same AS.On the other one, ...
Hi,I try to implement SRv6 Service Chaining.I have a VRF on a PE routeur with two host on this PE in this VRF.On an other PE (call PE-FW) i have the same VRF with a FW connected on it.I want traffic from host A to go to the PE-FW and go to the FW and...
Hello Guys,I have an AS9902 connection to a Nexus 9000v.On the Nexus i have configure a VNI and a VLAN association. I also have configure a peering with the ASR9k.On the ASR i have configure the EVPN VXLAN Layer 2 Data Center Interconnect Gateway. On...
Hello,I have a docker image.Working perfectly fine on linux but when i want to launch it on XR i have an error.XR:~]$ docker run -td --net=host --name test -v /var/run/netns/global-vrf:/var/run/netns/global-vrf -v /var/run/netns/VRF-A:/var/run/netns/...
Hello guys,I have some traffic comming on my port (300 Mbits/s)I want to capture the traffic to a file.I'm using this doc :https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-5/interfaces/configuration/guide/b-interfaces-hardware-...
Hi @decode.chr13 @Harold Ritter @Cristian Matei ,Thank you for your answer.I put a schema of my scenario.What i want it's that my PE has all the route of each cilium announcing the VIP 1.1.1.1/32.I attach two scenario. The one that i have. My PE-1 ha...
Hi @Aleksandar Vidakovic ,Thanks for your answer.In fact we need to put the C-BIT to 0 it will allow the fortinet in front of us to maintain is forwarding.There is an extract of our bfd with the Fortinet :They send the C-BIT to 0 and we send it to 1....
Hi @Aleksandar Vidakovic , We have implemented BFD and BGP graceful restart features to maintain traffic assuming connection loss between BGP peers. The hosts are not directly connected that's why we have BFD enabled to fastly detect link failures. B...
