Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Routes in route table not sent to bgp peer at 10.0.79.70 but only two subnets sent. Need to send them all including default route.
<hostname removed>#sh ip bgp nei 10.0.79.70 advBGP table version is 1840, local router ID is 172.16.159.17Status cod...
Unable to remove the load network config file via tftp. I find this in the show version on a 3650. The switch is prepared for IOS upgrade but I found a tftp config file in the show ver. I dont want to reload the switch as I would rather load the ...
Looking for assistance to get started configuring WAAS on a ISR4351 with built in SM controller.
I can not seem to find a interface to setup. I tried playing with Service Engine interface but not getting anywhere.
Interface IP-Address...
I have a router connected to MPLS network for Primary access and EZVPN for back. MPLS and BGP look stable and routing table is stable. Telnet/Ping access thorugh MPLS to router is good but can not reach anything on the LAN side of the router. Not ev...
I have several 1941/k9's that do not have the class-map command: to suppot ssl. System image is c1900-universalk9-mz.SPA.152-1.T.bin.class-map match-any af31match protocol ssl <-- missing. I did some google searches but come up with nothing. Is the...
Found the problem. Route map inbound from PE had this:
set community no-export additive
This command was telling BGP not to forward these subnets out another EBG process.
Removed no-export additive and works find.
Thanks all.
My router is receiving updates from layer 3 switch but only sending connected subnets and not any subnets from routing table.
Gig0/1 is the port connected to layer 3 3850 switch
G0/2 is coneected to a MPLS PE router.
pbserv-uschi300-re01#sh ip b...
